Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

RF switch device width

Status
Not open for further replies.

jcpu

Full Member level 4
Joined
Dec 17, 2005
Messages
214
Helped
18
Reputation
36
Reaction score
5
Trophy points
1,298
Activity points
2,968
I am designing RF switch.
And need advice about how switch device width is decided.
Thanks in advance.
 

I think that the switch width is going to depend on the power handling required and isolation level. The wider the switch is, higher the power handling but lower the isolation in OFF-state.
 
  • Like
Reactions: jcpu

    jcpu

    Points: 2
    Helpful Answer Positive Rating
Then please advise the device width you are using and how much power it's handling?
Thanks,
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top