Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

EP2C8Q208C8 ROM problems

Status
Not open for further replies.
L

lgeorge123

Full Member level 2
Joined
Jun 13, 2004
Messages
130
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Location
Hong Kong
Activity points
1,403
I search the data sheet of EP2C8Q208C8 cannot find the ROM SIZE of it , so is it have no ROM or what is the size of it if it have ??
 

I search the data sheet
Click to expand...
??
Cyclone® II devices feature embedded memory structures to address the on-chip memory needs of FPGA designs. The embedded memory structure consists of columns of M4K memory blocks that can be configured to provide various memory functions such as RAM, first-in first-out (FIFO) buffers, and ROM.
Click to expand...
EP2C8 has 144 respectively 165 kBit available (8 resp. 9 Bit organisation).
 

I don't think there's any ROM in FPGA, all you need is ram, because ram can be simulated as rom.
and if you need a rom to store your code, just use EPCS device
 

Hi , sicheng163 , can you give me more information about using EPCS , can EP2C8Q208C8 using it without external ROM ?
 

lgeorge123 said:
Hi , sicheng163 , can you give me more information about using EPCS , can EP2C8Q208C8 using it without external ROM ?
Click to expand...

EPCS series chips are configrution devices for altera FPGAs,
such as EPCS4/EPCS16
of course you can design a FPGA board without ROM, then you have to download your code with JTAG everytime after power up,
 
what configration I need in quartus in order to store my code in rom ???
 

lgeorge123 said:
what configration I need in quartus in order to store my code in rom ???
Click to expand...

Actually you don't really need to config anything, just download your code into EPCS chip, with AS mode JTAG form quartus programmer (Active Serial Programming)
then when power up, FPGA will get the code from EPCS,
so, all you need is AS mode JTAG and an EPCS chip and a FPGA
you can get more details from the datasheet of EPCS
 
according to EPCS64 datasheet it is a 64M bit memory IC , can it used to store 4M size code without flash memory ???
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top