Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

DRC error Orcad Capture WARNING: [DRC0008]

Status
Not open for further replies.
J

jgeens

Newbie level 3
Joined
Aug 17, 2009
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,300
DRC error Orcad Capture

This is how I have made my connection (only look at the horizontal connections):
On page1:
**broken link removed**



On page2:
**broken link removed**

If I look at the DRC it sais this:
Checking Off-Page Connections
WARNING: [DRC0008] Two nets in same schematic have the same name, but there is no off-page connector G1-DA-OUT5
Matrix1, Matrix1-61 (26.42, 49.53)
Click to expand...

When I look at the nets I see this:
**broken link removed**
Why does the nets dont have the same name? And I can't find a net with that name (G1-DA-OUT5_xxxxxxx)
 

Re: DRC error Orcad Capture

Sometimes if You have a port and a line, but only on the line have the netlabel, then there is a mismash, between the port and the lable as these are NOT connected together any way. Between the chip and the port set the netlable.
 

    J

    jgeens

    Points: 2
    Helpful Answer Positive Rating
Re: DRC error Orcad Capture

jgeens said:
This is how I have made my connection (only look at the horizontal connections):
On page1:
**broken link removed**



On page2:
**broken link removed**

If I look at the DRC it sais this:
Checking Off-Page Connections
WARNING: [DRC0008] Two nets in same schematic have the same name, but there is no off-page connector G1-DA-OUT5
Matrix1, Matrix1-61 (26.42, 49.53)
Click to expand...

When I look at the nets I see this:
**broken link removed**
Why does the nets dont have the same name? And I can't find a net with that name (G1-DA-OUT5_xxxxxxx)
Click to expand...

Test thes solution.
 

    J

    jgeens

    Points: 2
    Helpful Answer Positive Rating
DRC error Orcad Capture

Thank you everyone. I forgot to put a label on my net...
 

Re: DRC error Orcad Capture

use off page connectors on all the pages. only then will they be interconnected.
hock
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top