Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
One solution might work. OrCAD and Capture CIS are very much alike, thus it is not nesesary (sorry missplelling) to use device files. Devicefiles are good for 3. part netlists (read non-Cadences).
Dip8 foot print and and the padstacks of it are may not be assigned properly or check the path in allegro whether u have assigned libraries correctly or not.
once again save the padstacks of Dip8 in ur located path folder.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.