Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

image frequency interference in bluetooth standard

Status
Not open for further replies.

yubingz

Junior Member level 3
Joined
Feb 21, 2008
Messages
31
Helped
3
Reputation
6
Reaction score
0
Trophy points
1,286
Activity points
1,436
bluetooth interference 2009

Hi,

What's the "image frequency interference" and "Adjacent (1 MHz) interference to in-band image frequency" in bluetooth standards?

thanks!

Yubing
 

inband image frequency

Thanks!

But if i use low IF architecture, how image frequency go into the in-band?

thank you very much
 

bluetooth in-band omage frequency

Imagine that you use a 1 MHz IF freq and you want to receive 2420 MHz.

You set your LO to 2421 MHz, for example.

If an interferer appears at 2422 MHz, it will be downcoverted to 1 MHz in the IF strip and will be rejected by the amount of image rejection (that is dominated by inaccuracy of I/Q LO phase).

I hope this is clear enough.

Max
 

    yubingz

    Points: 2
    Helpful Answer Positive Rating
what is an image frequency interference

In Low-IF receiver, generally the image frequency is converted to IF frequency nears the channel bandwidth. The image can be rejected at IF using a band-pass filter. If the IF represents the Adjacent Channel of the receiver you get maximum suppression of Adjacent Channel Interferer.
 

    yubingz

    Points: 2
    Helpful Answer Positive Rating
bluetooth if frequency

Thanks Mazz! It's so clear.
But I still don't understand "Adjacent (1 MHz) interference to in-band image frequency" .
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top