Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

model of monopole in HFSS

Status
Not open for further replies.
I

ifelix

Member level 1
Joined
Apr 4, 2006
Messages
41
Helped
2
Reputation
4
Reaction score
1
Trophy points
1,288
Activity points
1,763
monopole hfss

Hi,
I want to simulate a wire antenna like a lambda/4 monopole in HFSS.
I've defined a cylinder filled with copper and a ground plane.
But how I define the excitation for the antenna?What I have to use and how?
Thanks.
 

hfss monopole

You can use a lumped gap port on a 2D rectangle between the wire and the groundplane. Or you can use a wave port by assigning it to the outline of a circle on the groundplane (this treats the monopole like the inner pin of a coaxial line).

The impedance of the lumped port is assigned by the user, while the impedance of the wave port is found by the 2D port solver.
 
monopole antenna hfss

Hi ifelix,

I normally use 'driven terminal' analysis and waveports to simulate monopoles or dipoles with coax-feeds.

Hope this helps,
David
 
monopole+hfss

what difference between lumped port and wave port?
 

hfss monopole antenna example file

This is the example on HFSS document, in this case, they used waveport (not lumped port). Have you ever tested using lumped port?
 

monopole + hfss

I've created a coaxial feed with internal conductor connected to the monopole and calculated to have 50 Ohm as carachteristic impedance.
Then I've tested waveport and lumped port at the coax entry and I've obtained the same results.
I've looked at S11 and Zin and they are very similar. Also the Zin=36 Ohm about and this agrees with the theoretical value of lambda/4 monopole...
Regards.
 

hfss monople models

I learn HFSS v5 since two days ago, to model finite groundplane monopole antenna. I get difficulties in defining port.
Some members of this forum have been successful in modeling monopole antenna. Please send you monopole's hfss file to me. I want to learn from you.
Thank you very much.
 

hfss model monopole antenna

plasma said:
look at the example it will help you

pl
Click to expand...


Dear plasma:

Thanks for the document you support. It really help me a lot. Thanks.
 

2d port solver

does this also apply to hfss v9 and above?
 

monopole antenna using hfss

Hey I m designing lamda/4 monopole in HFSS. what length and diameter should I take? Plz reply urgently.
 

monopole +hfss

for lambda/4 monopole the radius of cylinder can be taken as lambda/200
 

    V

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top