hkBattousai
Advanced Member level 4
I'm new to Altium Designer. Before I used PSpice, Electronics Workbench and Proteus.
In these three schemtics software, after you make the wire connections of a circuit element, whereever you drag it the wire connections too will be redrawn accordingly to the new location.
But in Altium Designer, after you drag a part to a new location, its wire connections become disconnected. Like in the screenshots below:
Before: **broken link removed**
After : **broken link removed**
Am I doing the wiring in a wrong way?
Or does it happen this way in this software?
In these three schemtics software, after you make the wire connections of a circuit element, whereever you drag it the wire connections too will be redrawn accordingly to the new location.
But in Altium Designer, after you drag a part to a new location, its wire connections become disconnected. Like in the screenshots below:
Before: **broken link removed**
After : **broken link removed**
Am I doing the wiring in a wrong way?
Or does it happen this way in this software?