Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Noise analysis in Cadence

Status
Not open for further replies.
raduga_in

raduga_in

Full Member level 4
Joined
Aug 29, 2005
Messages
199
Helped
32
Reputation
68
Reaction score
10
Trophy points
1,298
Location
India's Silicon Vally
Activity points
2,357
Hi all,

Can someone tell me how to go about the Noise analysis for a circuit
using Specter and Cadence ADE ...

TIA

Raduga
 

You simply choose the noise analysis tab from ADE, specify the frequency range over which the analysis is done .You then specify the noise source and then run the analysis.
 

    raduga_in

    raduga_in

    Points: 2
    Helpful Answer Positive Rating
You need to add a voltage source and derive input-referred noise.
 

What is exactally the type of simulation: is it a NOISE simulation or a PNOISE simulation?
I think that is the NOISE simulation,but what is the ouput noise and input noise ?
 

I used NOISE. You can try the options in the settings.
 

    raduga_in

    raduga_in

    Points: 2
    Helpful Answer Positive Rating
I ask about the source which should added in the schematic. And, what is the input and output sources?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top