Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] LPDA printed antennas

Status
Not open for further replies.
G

guytoub

Full Member level 2
Joined
Dec 23, 2004
Messages
123
Helped
4
Reputation
8
Reaction score
5
Trophy points
1,298
Activity points
921
hello everybody!

i would like to design a printed log periodic antenna and i would like to know if you have paper about the calculation.
if the method is the same like a wire log periodic antenna.

thanks
 

It has been a while since I have made LPD. I have found the book "Log Periodic Design Handbook" by Carl E Smith particularly helpful. This is a "wire" based guide.

The antennas that resulted were PC based with coaxial feed lines operation in the 500 MHz to 20 GHz range.

The sizes ranged from a few inches long to around two feet for the lower end of the band.
 
hello,

i tried to have this book in my local library (in france) and unfortunately they don't have it.
please can you give me a link where i could buy it on line.

regards
 
Go through this IEEE paper and you can find the much more about the log periodic microstip antenna

desing of microstrip log periodic arrya
and
Microstrip log periodic antenna using circuit simulator
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top