Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to re-install Windows XP if you have two other systems?

Status
Not open for further replies.

husseinadel

Full Member level 3
Joined
Jan 25, 2006
Messages
156
Helped
19
Reputation
38
Reaction score
6
Trophy points
1,298
Location
EGYPT,CAIRO
Activity points
2,647
re-install

AA

i want to re-install my windows xp,,,,the pb is that i have windows 2000 server on drive C, windows XP on drive d,and linux fedora core3,,, i want just to er-install the XP,,but the others still installed,,,,is there any problem in that or i must do something other than usual?!!!! note that i have very bad ground with linux


thanks
 

Re: re-install

husseinadel said:
AA

i want to re-install my windows xp,,,,the pb is that i have windows 2000 server on drive C, windows XP on drive d,and linux fedora core3,,, i want just to er-install the XP,,but the others still installed,,,,is there any problem in that or i must do something other than usual?!!!! note that i have very bad ground with linux


thanks
WA,
u should copy the boot.ini file , re-install the XP , then recopy the boot.ini, now u should have both XP and 2000 server working , u will have to reinstall GRUB loader ,to do so follow the following:-
1- boot using CD1 of FC3.
2- dont enter graphical mode but instead enter the following command linux rescue
3-enter the following : chroot /mnt/sysimage
4-enter the following : grub-install /dev/hda --note i assumed that ur disk which u want to boot 4m is hda , u should change it according to ur disk "can be hdc in case of two disks , i think hdb is for the CDROM"
5- enter : exit >>>or just restart


notes: 1-u should copy the boot.ini file to/from the partition u are booting from,"C" (if u have one HDD) , this should also be done with grub as hda should normally
"but i am not sure" ur booting partition , this may change in both cases if u have another HDD.
2- if u have one HDD , i think u may skip the boot.ini step as u wont need to format the MBR on C , as ur XP is one D, so just format D from server2000 re-install XP, and both the new XP and server 2000 should be working fine .
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top