Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

What is frequency multiplication ?

Status
Not open for further replies.

narasimha_80

Newbie level 5
Joined
Nov 29, 2005
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,368
multiplication freq

Hi,

Can anybody pls tell me help me regarding following questions ?
1. what is frequency multiplication ?
2. What is bus constraints ?


Best Regards,
Narasimha Naik
 

frequency multiplier tpub

indeed freq.multiplication very important in modulation systems....bcoz it needs high frequency signals as a carrier....produce that high freq. will damage the stability of the oscillator ..ultimately the last resort is freq.multiplication by means of freq.multuiplier or harmonic generator
 

frequency multiplication

Thanks for your reply.
I am sorry, I did not get properly. Can u explain bit more ?

Regards,
Narasimha Naik
 

what is frequency multiplication

ok..
1)MODULATION needs high frequency signal as its carrier ie.after modulation output is nothing but high freq which contains carrier in it

2) some where filter will be needed to eliminate some high frequency components from modulated wave(nature of the method) .all filters will deviate from its characteristics once it's freq. of operation increases
as a solution ,perfrom modulation at lower level and than eliminate all wanted components at lower level after that go for frequency multiplication or translation to convert it in to high freq. (lower level---at low freq)
 
To add few more points..... Just check the following link which describes what a frequency multiplier is....

**broken link removed**

For the bus constraint......
Drive strength, type of logic (TTL, GTL, LVTTL), Pin lock (in case of PLDs) will be specified thro user constraint file in some standard format. That once againg depends on the tool vendor.
 
Frequency multiplication is differnt that frequency modulation!!
Multiplication is to get use of multiples of the input frequency of the circuit fin -- m*fin.
This is done by passing the inout frequecy through non linear element. This wil generate the multiples of the input frequency. After this we use a sharp BPF to select the wanted multiple.
Frequency modulation is to modulate the output frequency by another signal like we are doing inFM circuits.

Bus constrains is wide area. They may fan out limitation of the bus, dealy of the bus, max speed of the bus ......etc.
 

I agree with haytham,
i want to add frequency multiplication can be done
with pll (phase locked loop) circuit (plus frequency divider).

Regards
داود عامریون
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top