Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Just google around for "Line Coding", lots of hits. It usually describes the logic representation of "0" and "1" bits.
There are other coding techniques other than line coding.
From a stream of raw data, you first carry out source (aka compressional) coding, then channel (aka error correction) coding, followed by line coding, then modulation. On the receiver end, you carry out the reverse.
As for RC5, I would term it more of a protocol than a code, normally used with remote controls.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
