Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Back light design of cell phone, PWM, PFM or Charge PUMP ?

Status
Not open for further replies.
B

Btrend

Advanced Member level 1
Joined
Dec 26, 2003
Messages
422
Helped
71
Reputation
142
Reaction score
14
Trophy points
1,298
Activity points
3,984
pwm in cellur phone

Hi experts,
Could u tell me, what kind of topology is suitable in back light deisgn of cell phone using while LED driver ?
there are a lot of advistments of IC vendor for this, some vendor said that their PWM solution provide lower noise inject to the batter source, but some vendor insist there solution (PFM) is much efficiency then PWM (but they don't address their noise issue ), some others assisit their Charge pump solution need only cap,
(but they don't address power loss in resistors of each branch ).
So, what's the real case in designing such back light of cell phone ?

Thanks in advance!
 

it depend on your system requirement.
For Charge Pump: low noise for rf circuit, but the efficiency power rate is low.
For PWM: provide lower noise inject to the batter source, but the noise big for rf circuit.
For PFM: the efficiency is best in the three kind but noise is biggest.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top