Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Is antenna gain unit dBi or dB in HFSS results?

Status
Not open for further replies.
tony_lth

tony_lth

Advanced Member level 5
Joined
Jul 28, 2010
Messages
2,086
Helped
377
Reputation
756
Reaction score
368
Trophy points
1,363
Location
Beijing
Activity points
12,623
Hi, Gurus,
In HFSS design, the radiation is a "Infinite sphere1", with theta and phi both from -180deg to +180deg.
Then I get a results with dB(RealizedGainTotal) at phi=0 and theta=0.
I want to know what is the unit for my result, dB or dBi?
My concern is such as in FCC document, it says that EIRP peak should be less than +55dBm.
So should I use my result dB value directly or add some 2.15dB or substract 2.15dB, when I evaluate the FCC requirement?
Best,
Tony Liu
 

Sort by date Sort by votes
Gain (specifically, Directivity) always has to be measured relative to some kind of source. In HFSS, I believe this is always dBi (even though it just says "dB"). You could check by simulating a dipole, which should have about 2.15 dBi of directivity.

In this case, you shouldn't have to subtract or add anything from the gain value. However, take care that your calculation specifies either gain in dB(i) or linear terms.
 

    tony_lth

    tony_lth

    Points: 2
    Helpful Answer Positive Rating
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top