Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Choose "it" in calculator and then click on the terminal where you want to see the current. Before the simualtion, you have to tell cadence that you want to save this current (outputs->to be saved) otherwise by default only voltages are saved.
Fist, before the simualtion, you must save this current (outputs->save all) otherwise only voltages are saved by default.
Second,select the outputs->to be plotted,then click on the terminal node of device that is analysed.
Third, run!
yes, and if you're a busy man like me, you can skip the outputs > to be saved, because it will ask you: some outputs wont be saved bla bla, so you click yes, and you can save like 2 seconds this way.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
