Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

What kind of industrial network is SERCOS?

Status
Not open for further replies.
E

epp

Full Member level 5
Joined
Mar 4, 2004
Messages
243
Helped
12
Reputation
24
Reaction score
4
Trophy points
1,298
Activity points
1,847
SERCOS

What kind of industrial network is SERCOS?
Thanks.
 

Re: SERCOS

Check w*w.sercos.com web site.
Generaly sercos use AC servo drives for comunication.I use sercos link with indramat and Hitachi ac servo drives.
w*w.st.com have sercos chip.But I dont remember ic number.
And below Hitachi sercos ac servo databook
**broken link removed**
 
Last edited by a moderator:

    E

    epp

    Points: 2
    Helpful Answer Positive Rating
Re: SERCOS

fuzzy said:
Check w*w.sercos.com web site.
Generaly sercos use AC servo drives for comunication.I use sercos link with indramat and Hitachi ac servo drives.
w*w.st.com have sercos chip.But I dont remember ic number.
And below Hitachi sercos ac servo databook
h**p://w*w.hiflexonline.nl/documentatie/pdf.zip
Click to expand...

Which other networks could be used also with AC drives?
 

Re: SERCOS

Ac drives use rs485 and profibus network
Ac servo drives use generaly sercos and some special own links (Omron,seie,baldor,,,)
 

Re: SERCOS

for: Fuzzy

I have use Indramat Servo Control type Hardware : CLM-01.3-A-0-1-0
Software : LA-01.3-002

I have trouble after power on, "System Failur ! Code #EXCP24" on LCD display

can you help me..?
thank's
 

Re: SERCOS

I hope next week may be write.
I know CLM but I dont use.But I have all documents.CLM old system but very strongly.I use SYNAX and VISUALMOTION.
 

Re: SERCOS

I send a message for your problem.And Indramat send this message.


Hello Serdar, it again to some extent goes. EXCP24 is a Exeption error by the microprocessor of the CLM is spent. The error can be caused by disturbances if for example the 5V-Versorgungsspannung is disturbed or if disturbances over the raster entrance to come. If you do not find in this direction anything can it also be that the CLM are defective. Exchange of the control

regards
Mr.Serdar Cetin
dizayn@efes.net.tr
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top