Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

HFSS- 0 Magnetic Field Plotted in Cylindrical Cavity Resonator

Status
Not open for further replies.
K

kaa165

Newbie level 1
Joined
Jun 9, 2016
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
12
I designed a cylindrical resonator in HFSS and analyzed the 8 eigenmodes at different frequencies as a geometrical quantity changed (in the Optometrics section). After analysis, the eigenmodes for the waves were being displayed at the correct frequency and the electric field plot was also correct. However, when I tried to plot the magnetic field and the current through the resonator, they were both zero. I did NOT receive an error saying, "The electric field is not available to be plotted." Is it an analysis error from HFSS? Is there an option so that the magnetic field is displayed?
 

I am not getting the whole picture.
But few things are clear that if electric filed is correct it means there should be corresponding magnetic filed as well.
Have you selected the right geometry to plot magnetic field?
 
Check the phase of the magnetic field plot. If the phase is 0 degrees the H field will be zero so set the phase to 90 to see the magnetic field.

Animating over phase should also show it.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top