Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to change width of line in Microsoft Office Paint for the already drawn figure

Status
Not open for further replies.
N

narayani

Full Member level 2
Joined
Aug 15, 2014
Messages
120
Helped
0
Reputation
0
Reaction score
1
Trophy points
1,298
Activity points
2,262
I am using Microsoft Office 2007 Paint to draw a my figures. What is question is, I have already drawn figure with more thickness line, now I want to change the thickness (width) of the each line of figure or all parts of the figure. How to change width or thickness of all the drawn lines or individual lines using Microsoft Office 2007 paint.

I have attached already drawn my figure below, now I want to change all lines in my figure.
 

Attachments

  • Fig. 6.jpg
    Fig. 6.jpg
    49.7 KB · Views: 111

Select the required part of your figure using select tool, then right click and select resize option.
 
In paint It looks like this
Clipboard02.jpg
Select line for drawing from left panel
Clipboard01.JPG
Line width is shown in lower most part on left panel, select the desired width from list available.
Clipboard03.jpg
 
ark5230 said:
In paint It looks like this
View attachment 118245
Select line for drawing from left panel
View attachment 118246
Line width is shown in lower most part on left panel, select the desired width from list available.
View attachment 118247
Click to expand...
Dear Friends,
You didn't understand my question, You have advised me to do that you take new line and take the desired width of line. But I don't want to take new line and change the width of line as we desire. As I have shown in the figure posting # 1, already drawn old figure is there, for that old drawn figure, I want to change the width of each line of old drawn figure. That is my question, how to change old drawn figure width of line.
 

I tried Resize but it shortened the line while making it narrower which is not what you want.
 

Attachments

  • Microsoft Paint resize.png
    Microsoft Paint resize.png
    54.7 KB · Views: 135

I doo'd (did) it.
in Resize, I needed to uncheck the box called "maintain aspect ratio" then I could resize the vertical or horizontal of the lines.
 

Attachments

  • Microsoft Paint resize2.png
    Microsoft Paint resize2.png
    53.3 KB · Views: 108

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top