Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Transformer Winding machine?

Status
Not open for further replies.

ambi

Member level 1
Joined
Mar 31, 2015
Messages
32
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
199
HIII.,

Is there any possibility of building your own simple transformer(smps) winding machine? :-?
And if so would u pl suggest me any ideas?? :idea:

Thank you :smile:
 

Last edited:
  • Like
Reactions: ambi

    ambi

    Points: 2
    Helpful Answer Positive Rating
You need a foot operated speed controller. The most important part is the wire tensioning device. this is normaly a free wheeling pulley or two with a very light spring to keep the tension correct. It would be possible to use a weighted pulley " hanging" of the wire. If you are winding a transformer on a square former then the task is very difficult as when the former is rotated by a tiny amount, you need to feed a piece of wire the length of the whole side. I suspect that to wind at high speed you need a cam shaped square pulley which is synchronised to the main spindle. So the wire is fed as four bursts during one turn of the main spindle.
I did once work in a coil winding department and have wound coils up to 27,000 turns of 40 SWG wire, but only on round formers!
Frank
 
  • Like
Reactions: ambi

    ambi

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top