Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

3ph full bridge igbt driver

Status
Not open for further replies.
S

seyyah

Advanced Member level 2
Joined
Oct 7, 2001
Messages
646
Helped
8
Reputation
16
Reaction score
8
Trophy points
1,298
Activity points
6,233
full bridge igbt

Is there any single chip that can drive all of the six switches (igbts) found in a 3-phase full bridge both high side and low side? If not what's available for high side and low side especially more common ones?
 

driver igbt six pack

6-pack drivers are not very common but they exist.
Here is an example:
**broken link removed**
 

brigde igbt

IR2133 (for 600V operation) or IR2233 for 1200 volt from International Rectifier are single chips for 3 phase igbt drive
 

ıgbt 3 phase full bridge

Hmm good devices but aren't they a bit expensive? Are there any alternatives?
 

igbt driver 3 phase

I'd not expect these level of prices. But if these are normal prices than i can afford them. On the other hand tda350 is much more convenient from the view of price but i think it's not logic compatible (it's not clear.) Also there is only one input so the output is complementary i think. I may need independent control of outputs. But i'll keep it mind, thanks to all. Any other alternatives?
 


    S

    seyyah

    Points: 2
    Helpful Answer Positive Rating
1200 volt igbt drivers

IR21xx series may be help you .you can use 3 half bridge mosfet driver to form the 3ph full bridge driver
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top