Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear freind I have the circuit for the constant current and 13.6 v charger with over charging protector and deep discharging protector(9.1v) with CHARGE control and load protection when charging the battery
Dear freind I have the circuit for the constant current and 13.6 v charger with over charging protector and deep discharging protector(9.1v) with CHARGE control and load protection when charging the battery
Dear freind I have the circuit for the constant current and 13.6 v charger with over charging protector and deep discharging protector(9.1v) with CHARGE control and load protection when charging the battery
Check this out - **broken link removed** - just follow exactly the calibration procedure and it will work perfectly. I know because i built one, i'm using it to charge my 12v 7ah SLA battery. I hope it suits your needs and good luck
If the Voltage being applied can be controlled (13.8v - 14.2V), what will happen if I try to charge 7Ah battery with unregulated current (constant) source of 4A ?
Please clarify this point as I have a simple SMPS with this configuration.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
