Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Replacing 741 with OP07

Status
Not open for further replies.
J

jmx66

Member level 5
Joined
Nov 16, 2010
Messages
93
Helped
0
Reputation
0
Reaction score
1
Trophy points
1,288
Location
France
Activity points
2,045
Hi all,

I plan to build this power supply:

https://www.eleccircuit.com/high-power-supply-regulater-0-30v-20a-by-lm338/

I'm going to add 4 more LM338 to decrease power on each item.

4 Heat sinks: Fisher SK 88 with 2 x 12V fans, and a dedicated power supply for LCD panel meters also.
Length: 250 mm
Height : 100 mm

Only 2 questions:

- can i replace 741 op amp with OP07 , and if yes, no resistor value changed, like R1 by example ?
- is there a better replacement item for 741 in this power supply?


Thanks a lot.

jm

View attachment Datasheet-OP07.pdfView attachment Op07-Datasheet.pdf View attachment lm741.pdf
 

Hello jm,

yes, you can use OP07 in this circuit, because you don't need an offset adjust.

Other an better replacements are TL071 or TL082. These are also compatible with the offset adjust. You don't need any changes in resistor values.

Regards

Rainer
 
  • Like
Reactions: jmx66

    J

    jmx66

    Points: 2
    Helpful Answer Positive Rating
Hi Rainer,

Thanks a lot for your reply.

Now i can draw with my favorite EDA soft, Kicad, the whole circuit.

If i wanted to use TL071 or TL082, i must add voltage offset circuit?

Regards.

Jm

PS: Don't be sorry for your English, I have same concern when i try to read items from Reichelt or Burklïn, with no english translation in a few datasheet!!!!!!
 
Last edited:

Hello Jm,

sorry, I see one typing error in my post. It must be TL081, not TL082. TL082 are two OP in one case.
TL082 is not pin compatible to TL071 or LM741.

You must not change or add something, because TL071 and TL081 are fully pin compatible to LM741.

Regards

Rainer
 
  • Like
Reactions: jmx66

    J

    jmx66

    Points: 2
    Helpful Answer Positive Rating
Hi Rainer,

Thanks a lot for your fast reply.

Regards.

jm
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top