Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Eagle Pro: DRC...doing just a clearance check on the top layer only?

Status
Not open for further replies.
T

treez

Guest
Hello,

Is it possible to do a DRC whereby it only checks clearance and only for the top layer?
 

According to the manual, the DRC check is always performed for all layers. It might be possible to disable some checks by temporarily loading a different design rule set.
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Try turn off the display on the layers you don't want. I never try it, but worth a try.
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Try turn off the display on the layers you don't want. I never try it, but worth a try.
Click to expand...
You don't actually need to try.
All signal layers are always examined by the Design Rule Check, no matter if visible or not (DISPLAY command).
Click to expand...
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
With some DRC errors it will report 'xxx errors with yyy errors in hidden layers' or something similar, which may achieve what you need.

Keith
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top