oddbudman
Member level 5
Hey fellow eda folks
I'm looking to get a board mass manufactured and just need some help wrt which manufacturing method to choose.
I've been doing some reading and i'm a little unsure if this board will need to be reflow soldered on the top and wave soldered on the bottom, or if wave soldering can be used on both the top and bottom of the board.
Bear with me this is my 1st time looking to get something mass manufactured.
The board uses a mixture of smt components (top side only) and through hole components.
The board is fairly simple, attached is a picture of it.
If you have any suggestions wrt what will be the cheapest method of mass manufacture, or have any experiences/insights you want to share with me I would be most interested in hearing them.
Look foward to some replies.
thx
oddbudman
I'm looking to get a board mass manufactured and just need some help wrt which manufacturing method to choose.
I've been doing some reading and i'm a little unsure if this board will need to be reflow soldered on the top and wave soldered on the bottom, or if wave soldering can be used on both the top and bottom of the board.
Bear with me this is my 1st time looking to get something mass manufactured.
The board uses a mixture of smt components (top side only) and through hole components.
The board is fairly simple, attached is a picture of it.
If you have any suggestions wrt what will be the cheapest method of mass manufacture, or have any experiences/insights you want to share with me I would be most interested in hearing them.
Look foward to some replies.
thx
oddbudman