Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

LineSim basic tutorial

Status
Not open for further replies.

viperpaki007

Full Member level 5
Joined
Jul 2, 2008
Messages
270
Helped
11
Reputation
22
Reaction score
8
Trophy points
1,298
Location
Finland
Activity points
3,395
Hi,

I am new to Signal Integrity simulations and just started learning HyperLynx LineSim for basic Pre-layout SI simulations. Can anybody suggest some basic tutorial or lab to start doing my basic simulations. I searched on internet and i was only able to find Linesim user guide, which is quite general and dont tell much which exact components i have to use.

regards
 

Thanks 1a2s3d4f,

One basic question about LineSim. I need to use a 50Ohm characteristic impedance ideal driver in LineSim. Which component i should use for that. I tried to put some IBIS drivers but it is really hard to understand that where i have to put 50Ohm driver impedance in those models. I also tried with .MOD models in .tech.mod library but i am unable to understand the model parameters and how to change the driving impedance to 50Ohm. Can you help
 

Hi Viperpaki007,

You should be able to change the sink/source impedance. If you double click on the driver/receiver, there should be an option for you to change the internal impedance.

Hope it help.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top