Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Design need to close in different modes (Func mode, Test modes,TFT,ATPG ,MBIST etc).
Multi corner. In Lower technology nodes, design need to close with multiple corners like PVT corners.
The total process closing in these STA closure is called MMMC.
sam explained you correctly .. there are lot of details .. go through any of the application note .... but any ways .. in case u need any specific details .. then you can ask here.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
