Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to check xbee module to separate PCs?

Status
Not open for further replies.
M

misswah

Newbie level 3
Joined
Jan 12, 2012
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Philippines
Activity points
1,309
After configuring properly the my x bee modules, I want to test it by look-back communication.
How can I test it using hyperterminal when both modules are connected on separate PCs?
What specific hyperterminal commands should I use?

tnx ^_^
 

connect them to 2 systems and send a file or type text from one PC and see if you get the data on the other PC. If it is configured correctly then it will receive the data.
 

Thanks ckshivaram, however I didn't quite get your answer. Where can I send a file? Where to type text from PC? How?
 

you will have to use hyperterminal... then select the port and configure the terminal with 9600 8-N-1 on both sides. then type something on the transmitter, you should receive it in receiver side hyperterminal.

To send txt file; save a small file with extension *.txt. from hyperterminal select send text file. by selecting the path of the file and send it. the file should get printed on the receiver side.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top