Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
Here are some suggestions for you to design RF project.
In the PCB design of low-power RF, the standard FR4 material is mainly used (good insulation characteristics, uniform material, and dielectric constant ε=4, 10%). Mainly use 4-layer to 6-layer boards. In the case of very sensitive...
Hi,
Maybe you can try to use below way:
The process of transferring high-frequency energy from a coaxial connector to a printed circuit board (PCB) is often referred to as signal injection, and its characteristics are difficult to describe. The efficiency of energy transfer varies greatly...
Hi
I can share several things suitable for data transmission WiFi, BLE Bluetooth module.
OT WLAN WiFi module WU106
WU106 is a WiFi module that complies with the 802.11 b / g / n standard. It has a built-in in-vehicle low-power application processor. It is a low-cost serial WiFi module that...
Hi
The I-TERA MT40 from Isola Group is a Low-Loss Laminate Material, suitable for many high-speed digital and RF/microwave printed circuit designs. This material has a dielectric constant (Dk) of 3.38 to 3.75 which is stable between -40°C and 140°C up to W-band frequencies (75 to 110 GHz). This...
I am here to share some views and capabilities for Via in pad on PCB design.
The use of Via-in-Pad technology is increasingly influenced through the necessity of high-density BGAs (ball grid arrays) and the miniaturization of SMD chips.
With a reliable Via Filling / Capping process, without...
Hi
I am here to share some unusual PCB features encountered in previous pcb production.These may help Makers use your imagination in PCB design.
PTH on the Edge
It is also called “castellated holes”. These are plated holes cut through on the board edge and used to join two PCBs either by...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.