Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all
i'm going to design an infinitesimal electric dipole above an infinite pec for height lambda/2.I'm going to earn figure 4.17 in antenna book,Balanis but the results aren't good at all.(VSWR and radiation pattern)
i don't know how length i need for air gap in infinitesimal dipole?and...
Hi all
I have designed a cylindrical cloak in Comsol.I want to plot the polar plot of normalized power.How can I do that?should I export the data into Matlab?how?
I have attached my simulation.I'm using Comsol 4.4.please help me.
thanks in advance
Noise figure of balanced amplifier in ADS2011
Hello
I want to simulate the balanced amplifier in the attachment paper.I simulated the bias circuit of ATF54143 and got good results.when I use it in balanced amplifier,gain and stability factor are good but noise figure and S11 and S22 aren't...
Dear BigBoss
Even I changed bias circuit but I got same result(S12 and S21 equal to zero)
I think the ATF54143 block has problem,but I don't know what should I do?
Or is there any thing to replacement of ATF54143?
Hi all
I want to simulate circuits in this paper:"http://www.sciencedirect.com/science/article/pii/S1434841112001719".(There is bias circuit in attachment file)
I downloaded ATF54143 from Avago and draw bias circuit in ADS2011,but I get S12 and S21 equal to zero and other parameters aren't...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.