Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am doing simulation in CST schematic and microwave studio.
I have designed two loops antennas and connect them to Balun and Matching circuits.
However, the MWSCHEM block is not connected to the second output of Balun
My question, is how to connect the second output of Balun to MWSCEH...
Dear all, if I want to connect the S2P file that has two ports with one Balun for each port, is it right way to connect with a reference for each port or connect both to a single reference in S2P
Hi Romansh,
Thanks a lot for your reply, however, when I used discrete port for a single antenna it will export S1P and if I have two antennas, CST will export S2P so it does not tell if it is a differential port
The balun I am using is actually a 3-port network, so I was thinking how to...
I have simulated two rings in CST and I have S2P file exported to ADS
If I have s2p files using two lumped ports, how to connect this s2p file to a balun in ADS giving that these lumped ports are actually differential ports.
Shall I connect one of the balun outputs to ground and the second to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.