Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I am trying to do a simple simulation in HFSS v10. In the simulation, a plane wave is incident in air(half space) and propagates into a dielectric (half space as well). PML bondaries are needed on both air and dielectric sides. I created the PML boundary automatically but the scattered...
Hi,
I am trying to do a simple simulation in HFSS v10. In the simulation, a plane wave is incident in air(half space) and propagates into a dielectric (half space as well). PML bondaries are needed on both air and dielectric sides. I created the PML boundary automatically but the scattered...
Hi,
I have to define frequency as a variable in HFSS. However, I noticed I can not put variables in either the "solution frequency" in "Analysis setup/General tab" or sweep.
Could anybody help me with that please? Thanks in advance!
Michelle
I am trying to simulate Sievenpiper's structure in HFSS, but no matter how hard I try I still can not get right results. Especially when I am calculating 2 modes between the light lines, the frequency results of the first mode and the second mode are very close to each other. I suspect it's my...
Re: Simulating pec in HFSS
Thank you! savedadogs,
I am simulating pec is just to see if my settings will give reasonable results or not. I am not quite familiar with HFSS yet so I don't understand why a parallel plate will give the same results as pec or just air. Could you please explain it...
parallel plate waveguide hfss
Hi,
I am trying to simulate an infinite pec metal in HFSS. I used master/slave boundary to make the metal infinite and used pml boundary condiiton. I tried both the PEC boundary condition and a metal box(very thin) in simulation but neither give me right results...
hfss periodic structures
I am trying to use HFSS to get the dispersion diagram for periodic structures, say, UCPBG. I used PML boundary ended with nothing and master/slave boundary to simulate periodicity. However, I can not get right dispersion diagram. I don't know if there's something that I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.