Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am designing a ferrite rod coil antenna in CST for a low frequency RFID application. However, i am a bit confused about the correct port to exit such a type of antenna.
Can any one help me regarding this question.
Can somebody please tell me that which drawing tool can be used to present a filter with defected ground structure as shown in attached figure with annotations.
https://obrazki.elektroda.pl/4155389400_1419564781.jpg
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.