Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi FvM,
The RC load will be a serial circuit and it is going to be connected directly to the output of the generator. I assume that the output should have a high impedance if I want to be capable of measuring the RC constant.
RC charge will adopt different values, in the range of 500 ohms up to...
Hi FvM,
I'm sorry that I wasn't clear from the beginning. The rise/fall time is required to be in the range of 25ns without load.
When I connect an RC load, I should be capable of measuring the RC constant by "observing" the new rise/fall time. This generator is made to characterize the RC...
Hi chuckey and FvM
Many thanks for the prompt answer !
Loads impedance are always an non fixed RC load. The max freq to be used is around 20khz.
I'm able to generate the values for the high and low level, the problem comes when I try to build the signal by combining these two values. I do...
Hi everyone,
I would like to hear some opinions and ideas of to face the design of the following square wave generator:
It must be capable of:
Having a rise time in the order of 25ns
the higher value must be able to go from 0 up to 42v
the lower value must be able to go from 0 up to -5v
The...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
