Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
Thanks for your replays, I was expecting some part numbers, like thylacine1975.
I did not mention what parts did I choose so anyone can point me others, or to know if I'm on right path.
The microchip thylacine told was exacly what I'm thinking of, so maybe I'm on right track :).
Thanks!
Hello,
I have a new project that I need to work with external supply and battery when external supply is not used.
I'm thinking of a 5V external adapter, that will charge a 3,7V Lion battery, and my circuit should run at 3V3.
I need to detect when my system is on battery, and also charge the...
I'm currently working with the MRF24WB0 from microchip (STACK on microcontroller) and I have a 15-20€ budget for that.
I can reach 50€ for an embedded solution that share the same pinout/firmware on Wifi or Ethernet.
Digi Connect is what I'm looking for, it has Wifi and cable in the same form/pinout, but they are too expensive, the cost around 90% of my budget for my product :(...
I'm using microchip PIC18F family controllers.
I'm looking for Wifi and cable modules with TCP/IP stack builtin, so I can free my microcontroller resources.
I'm looking for a device that handles HTTP requests, and I only need to configure, ip/dhcp and access point and the module deal with the...
Hello,
In my project I have to use ethernet network, either by ethernet cable, or Wifi.
I'll use HTTP client, since my board will access a webpage.
I need two modules (one with ethernet, other with wifi) that uses the same firmware, and comunicate with my micro (UART/SPI/I2C), so I can easly...
Hello,
I'm working on a project that I need an Android "tablet" style, but with open frame/OEM tablet, since I want to make my own box for it.
I'm looking for something like this "http://www.garz-fricke.com/santaro-104-openframe_en.html".
Do you know any alternatives?
Usually it's cheaper to...
@ZASto
Thanks for the tip.
@ard
My project connects to the tablet, using a micro controller so I need D+ and D- free.
I'll use microchip accessory firmware.
Hello,
I'm developing a system with a Tablet.
The system will run on a car (12V), and I need to charge the tablet from my circuit.
I think I'll need about 2A for a 10" tablet charger, does anyone have a small/cheap design so I can convert 10-18V of the car to 5V 2A?
I've found out a cheap...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.