Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you for your reply.
Do you mean that I put the FB41 in OB35?
I have an application program,If I attach it, would you please help me to fix it?
In its realted Db, the initial value is Manual mode,but it will go to Auto mode,I want to find out the parameter that makes it Auto.
I do...
pid s7-300
I intend to define a PID controller with FB41.
I would greatly appreciate if someone could help me about following issues?
1- how to link the OB3x to the block of PId controller?
2- how to define the cycle time in OB3x?
I would be thankful If one could give an examole about the...
plc s7 400 communication
I have recently faced a problem for our PLC(S7-400) which controls our Electro-compressor.(you can find our configuration in this address:)
Our PLC has communication wit site via two paths, one is via "Fiberoptics Module Profibus"(OZD Profi 12M) and the other is via...
siemens s400
I have recently faced a problem for our PLC that is controlling a Electro-compressor.
Our PLC has communication wit site via two paths, one is via "Fiberoptics Module Profibus"(OZD Profi 12M) and the other is via ET200 S(IM151: 6ES7 151 -1AA02-0ab0). The problem is the IM151...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
