Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
since I want to simulate the S-parameters of the balun later inside a harmonic balance simulation, my max. freq. is 20 GHz (5th harmonic of 4 Ghz, Design frequency 1-4 GHz).
I tried SMD calibration but it does not work in this case because you can not place several SMD-calibrated ports on...
I need finitite ground as it is part of the balun. The design is for a Push-Pull PA. The two microstrip line on the right side of the image will be the connections to the drain pins of the transistors and to the left there is the unbalanced output. There will be a cooling block underneatch the...
Hello,
I am currently trying to simulate an output balun for a power amplifier with ADS Momentum. I am having trouble with some ports for the DC-blocking capacitors though. I set up the simulation with a finite ground plane and want to simulate with ports for the blocking caps on both the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
