Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
thanks angain
Here is my real circuit :
suppose a 20VPP signal in inputs of AD8138 , it will be clamped at 5.6 V? (this is what i want )
is there a smarter way to do that ? , what about TVS bidirectional diode ?
thx
Thank you for your answer , the circuit shown above is just an exemple found in a book , my application will be powered by a +/- 5V
My worries were about the number of components ( 4 signal diode + 2 zener) , i think it may exist a package which include at least signals diodes but i don't know...
Hi
I was wondering , what is the best way for an input protection on a fully differential amplifier
i found this in AOE :
I'm using a AD8138 from analog , powered by a +/-5V , i would like to clamp inputs within the rails supply
Is there a smarter way to do it ?
thx !
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
