Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello all,
I'm using a Licence Ares version Proteus 7.9. I'm designing a circuit board with Ares. I'm not using he Isis schematics do it as there was not enough components I wanted.
The problem is by doing so I cannot create a Power Plan on the soldering side that has the gaps between the pads...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.