Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Isolated DC-DC Converter Sports Dual Outputs
Presented here is an isolated 6-W dc-dc converter optimized to provide low-cost and efficient isolated power across a 2500-V ac potential barrier. The converter, which incorporates inexpensive, readily available components, can provide either two...
It will be better if we could detect rain 'without measuring the amount of rain'. How does piezoelectric transducer in modern telephone ringer looks like?
Method by ASULAB is good. Any other ideas? Thanks.
Has anyone idea on how to build a "raining" detector in such a way that the device will give a signal telling that it's raining outsides the house? Thanks.
16f628 pl2303
Try USB-RS232 converter from FTDI company.
Or, try to use this ucontroller frm microchip: PIC18F4550
"... the availability of three serial ports: FS-USB(12Mbit/s), I²C™ and SPI™ (up to 10 Mbit/s) and an asynchronous (LIN capable) serial port (EUSART)"
You may consider 'offline smps'. It's possible to find Integrated Off-Line Switching Regulator (e.g. NCP1000, NCP1001, NCP1002, etc) that can function in continuous operation over a wide range of inputs, from 85 Vac to 265 Vac. But 380Vac... err.... may be you still need a step down transformer...
Bought a home telephone set last week. However, I found out the volume of the telephone set is too low or soft. Is there anyway to increase the volume? There is no button for me to increase the volume. Pls advise and thanks in advance.
P/S: NOT the ringing volume
request linear tech sample need money
I think coolchip is right. You need an organisation email. I think TI has stopped providing samples to users with Yahoo or Hotmail email account. Pls correct me if I'm wrong.
High-Side-Driver is used to drive High-Side-Switch (e.g. mosfet or IGBT), where one end of the switch is connected to Power-Rail, and the other end is NOT connected to ground.
If you mean the peak/dip at rising/falling edge of 'switching signal' (PWM signal to gate), then you should add a resistor in series to the gate of the mosfet. If I'm not wrong, larger resistance value will increase the rising time, and therefore reduce the peak magnitude. However, switching...
Visual Basic, in my opinion, is the easiet one if you wish to communicate with uC via serial communication. For USB communication, you need a specific driver. You can try using USB-Serial (USB-RS232) chip frm FDTI https://www.ftdichip.com/
about Matlab
In Matlab simulation, you can save the state of the simulation. This is particular useful when the system resources (e.g. memory) are not enough. In other words, you can divide the simulation into multiple stages. At each stage, you save the result to a different file. After all...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.