Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you for your replies. If it is okay, I have additional questions.
For now I am assuming a signal strength of less than -10dBm as input to my rectifier since I have yet to connect the antenna.
Does this mean I should be using a vpulse input instance in the schematic test bench instead?
I see. Thank you.
The rectifier I am trying to design has a differential input with cross-coupled configuration.
I am trying to evaluate the Input Power to the rectifier.
I have not yet considered the input impedance of the rectifier and the matching between source and rectifier since I am...
Thank you so much for your replies. If it is okay, I have additional questions.
Do you mean that I should assume a non-modulated signal drive for the wifi signal input for the rectifier since I only need the power delivered?
Would this be a correct setup for the port power source?
**broken...
Hi
I'm trying to design a rf energy harvesting circuit specifically at the wifi frequency of 2.4GHz in TSMC 65nm. The circuit design is a rectifier with a differential input. My question would be on the test bench of the circuit. Is it possible to only use a voltage sinusoidal source for...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.