Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Power balance?is it the "balance" in the 1D results?and actually what it indicated for.Now i'm designing a tag antenna,but my result is quite different for the -20dB and -30 dB.so mean that -20 dB result is not accurate and i should try increase my accuracy to -40 or -50dB to see whether the...
May I know where i can look for that energy balance?and is it you mean that for the correct accuracy, we will get the the same result even we increase the accuracy value?
Adel_48:
You say that just connect the coaxial directly to the dipole or use sma with a via,but the dipole have two element need to connect with the coaxial or sma only have 1 pin,so how should i connect them?thanks...
hi everyone...
For the transient setting of the "accuracy" part, is it must be set below -30 dB?if i set it -20dB,how i can know that whether my s parameter is correct or acceptable or not?
thank you.
now i'm designing a dipole antenna with apply the discrete port in between the gap.But the problem is I don't know how to implement it to the hardware part, so is it anybody know when i fabricated it on the PCB,what kind of connector i should use to do the measurement on return loss and...
Now i working on the design for the RFID inlay..but the problem is i cant get the datasheet for the PET(eg:thickness and epsilon).Anyone know where i can get it?thanks you...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.