Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have no idea,maybe it is so expensive,and which kits made by Actel are expensive,too.Every time,buying kit make my wallet empty. ^_^ I am waiting farhada to make one kind of smartfusion and send to me as a present.
hi ultralowpower
I think you can use MSS I/O to connect LCD.I am thinkting the question,too.PIN which on Smartfusion kit is so small, they are inconvenience to use.
thank you,I will do my best,I am wanting to everyboy give me good advice.I have a see a kit in China like below picture.I think that kit is better than smartfusion eve kit made by ACTEL.
hello,
I want to use a 4.3' LCD,and driver by MSS I/O.Maybe I will add a SD card on board to save picture,I do not like which I/O on SmartFusion,they are so small,and hard to use,I will make a kit like ACTEL's to connect to Smartfusion. if someone have intersting,can join together
in China, I have buy A3PN030,less than 2 dollar.
---------- Post added at 08:07 ---------- Previous post was at 08:06 ----------
I think is good for your design.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.