Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
the feed impedece pls !!
- - - Updated - - -
50 ohms ?? wich feed you using to simplify the calculation of the feed point to get a proper impedence adaptation
coax is th better technique cause that's allow you to control the input impedence in deplacing the feeding probe into or farther then the short circuit !
i think i helped thx
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.