Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
If I want sending data through serial port, when data type was string; I will use from this code in c#: port. Write (string name)
But, if data type was byte, what code should I use in c# language?
Please guide me?
Best Regards
Hi,
I know that 8051(microcontroller) has an UART (Universal Asynchronous Receiver/Transmitter) itself, but CPLDs have not it.
Now, should I use from an UART chip for connection serial port to CPLD? (Yes or no)
If yes, what is type of chip? and should it use ago or after MAX232?
If no, is...
Hi,
I wrote a driver program of serial port with c#.
I have a problem about programming serial port & parity codes.
Please guide me.
Please one of friends gives me an email address for that attaches my program with her/him.
Thanks a lot
Hi,
I have a problem about connection JTAG & my FPGA.
I have connected JTAG to my FPGA correctly.
My FPGA is "epm 7032 slc44" & my JTAG is "byte blaster mv".
Also my software for programming is quartus.
But after programming process appear bellow message:
"JTAG ID CODE SPECIFIED IN JEDEC STAPL...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.