Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
jtag voltage
hi friends
i use xilinx CPLD XC95216 .i want to utilize it as it's mixed mode which VCC_IO should be connect to 3.3 and VCC_INT to 5 volt.
how about JTAG pins ? should be connected to 3.3 v or 5 v ?...why ?
tnx
fsm encoding algorithm
hi all
what's difference b/w One-Hot Encoded Finite state machin and Binary-Encded FSM?and why does former is suitable for FPGA and later for CPLD desogn?
tnx ahead
dear nozone,u must follow web_download_instructions doc is in icflow documentation.anyway answer of ur question is here:
1.Change directories to the<install_directory>:
$ cd <install_directory>
2.Restore the install directory:
$ tar xfv install.ixl
Theinstall8 directory is one of the extracted...
hi everyone
i would like to install icflow2002 but when i run install.ixl a window appear and i could select IC Station and IC Design Architect then i loaded them.but i do not know somewhat i must do after this since there is no option to continue installation.
BTW,i do not know how i can set...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.