Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I'm sorry I'm a student.
Too much detail will not be, so I show my measurement results.
Each end is an isolated probe.
See your advice, I thought, I was not wrong mode. So I switched the mode to DC coupling.
haha...........(I am an idiot........
Sorry for my first use ...
I want to express the place where the red mark is, why is there voltage and current?
No gate trigger, why is there a voltage and current.
Found that there is leakage voltage, leakage current !!!!!!!
When the angle becomes smaller, it will happen.
Is it normal ???
What is the reason ??
How to improve??
Layout of the circuit
15° There is a clear leakage voltage
90°
150°
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.