Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I am very new to ST microcontrollers and wanted to know if someone can help me with a schematic for the STM32F302R8T6. The hardware I am designing is a USB to CANBUS tool but I need to know whats the minimal circuit needed to run this microcontroller at 72mhz. Below are a few parts I would...
Read, Write, Erase, Programmer
Hello,
I am looking to design and create a OKI Semiconductor In Circuit Programmer to do a Memory Dump.
The Device I am looking to Read, Write, and Erase to is an OKI - L66Q592 It is a 144pin LQFP
Need to Develop a Programmer that will allow me to read, write...
Hello,
I have a Hex file for a PIC16f877a. Its a simple ADC. But i do not have the original Source code. I have the Hex file. I wanted to know what is the smallest PIC can i use to program the hex file to and it will work?
Is there a conversion Process?
Hello,
I am looking to create a sample and hold design. The design must consists of changing voltage and being able to lock the the voltage in. The voltage control would be changed by a Joystick. The further the Joystick left or right the higher the voltage change. The joystick can then be...
Hello I have a AT45DB161D-SU chip(SOIC-8). I wanted to know what is the Cheapest Programmer I would need to Read and Write to this chip?
Also any adapters or Sockets I may need to complete this operation.
Could I use a ICSP cable to read and write?
Your insight is grealty appreciated
Thank...
Yes i want to use 2 accuators. Left and right, and back and forth.
As for the clutch it would be manually pressed triggering a push button switch to select a new gear.
The throttle pedal will be manually controlled too. The only thing that is automated is the shifting of the gears(exactly as...
Hello Edaboard Users,
I wanted to know if anybody has successfully unlocked either of these IC's. I have both IC's and they are locked. I would like to extract the JEDEC code to program to multiple blank ones.
Thank You
Hello,
I am looking to create a device for my car for shifting the gears automatically by a push of a button. The transmission is set up in a H pattern formation as any standard manual car. .. I want to Program a Pic Micro-controller to control two pneumatic or electronic actuators...
Hello Kripton,
I was able to assemble the ASM file you provided for me. But there is a difference in the output file SIZE....The original HEX file is 40.4 KB, the New Hex file is 46.4 KB. When I try to program the New hex file the output information says:
NEW HEX FILE
Programming Target...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.