Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
In the tracking mode, when CLK is high, M2a and M2b are on. So, the input pair, M1a and M1b is enabled and M0 as a current source will draw current flow from M6a and M6b. while to perform latching mode, CLK is goes low, M2a and M2b are turned off, disabling the input pair. M4 is off, and then...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.