Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i am using IR2110 and 740 for motor control
in my circuit i use 100ohms resistor and 1N4148 in parallel HO,LO to Mosfets Gate.
47ohms at VS pin.
inputs volts is 280v.
the mosfet gets heated more 80 deg.
but the motor runs well.
what can be the problem ?
did i need to change the resistor values...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.