Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
If I run simulation on power gated netlist, will the resulting SAIF file contain the effect of when certain domains were off due to control switch during the simulation turning that domain off?
Is it do-able in Synopsys Design Compiler/Power Compiler??
Hello!
Looking for suggestion for Master's Project in ASIC. I got interest in GPU design.
But I'm cool with any latest area of research/algorithm being implemented in my project.
If you don't have any suggestions about Project ideas, can you at least guide me how to get an idea for the project...
how to add 2nd stage on single ended folded cascode? i cant figure it out,, kindly tell me, its urgent.
im getting gain of 72dB and 100MHZ + ug FREQ.
SO HOW TO ADD CS AMP to increase gain to 100dB????
im using NMOS input folded cascode
how to add 2nd stage? i cant figure it out,, kindly tell me, its urgent.
im getting gain of 72dB and 100MHZ + ug FREQ.
SO HOW TO ADD cs AMP to increase gain to 100dB????
see attachment
so for following specs, I am trying to use folded cascode followed by common source amp.
i did the fully differential mode folded cascode n got around 76dB gain with all other specs in line, my question is how to add CS Amp at out of folded cascode?
1. 2 CS for each output of DM Folded cascode...
Re: Op Amp design for required specs
so at the output of folded cascode, i will place a common source amp, and it will provide me gain. how can i manage stability, i mean how to apply miller compensation capacitor?
as i said, im new to this
Re: Op Amp design for required specs
I heard about gain booster, will it work for single ended folded cascode as im trying to avoid common mode feedback, or gain booster will only work with fully differential folded cascode?
Moreover can you kindly give me insight of gain booster , i mean what...
Hey! I'm new to analog circuit design and am looking to design an op amp that can provide following specs:
DC open loop voltage gain > 100 dB
Unity gain bandwidth > 100 MHz
Phase margin between 70 and 75 degrees at unity gain
Vout swing > 2.0 Vp-p (single-ended)
Load capacitance = 1 pF
Minimum...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
